Color - white

PA6 (Polyamide) is a thermoplastic based on cast polyamide. Has excellent hardness and elasticity parameters. Therefore, it is often used in the manufacture of guide, back-up and support elements in the combined profiles of seals and rings, where the high degree of sliding is required. Considering the low performance in moisture resistance, it is not recommended to apply PA6 in media saturated with water.

PA6 Material Data Sheet

Properties Value Unit Standard
Hardness 85 Sh D ISO 868
Density 1,13 g/cm³ DIN 53479
Ball indentation hardness 153 N/mm² DIN 53456 H135/30
Tensile strength 80 MPa ASTM D 4745-79
Elongation at break 40 % ASTM D 4745-79
Compressive strenght 110 MPa DIN 53455
Coefficient of thermal expansion 8 1/Kx10-5  
Coefficient of friction 0,4 µ  
Min. service temperature -40 °C  
Max. service temperature +110 °C  

All above established data results from random tests which were taken from the functioning production. All data was stated based on standard test-products in accordance with ISO, DIN and ASTM standards and can substantially not be extended to the completed seal. Our practical technical recommendation, either oral, written or through tests is given in conformity with our best knowledge. However, this data is to be regarded as non-obligatory advice, also taking into consideration any protective rights of a third party, and does not acquit you from making tests with our product in relation to its adaptability for the assigned process and intendment. Utilization, application and processing of the products befall completely outside of our control and are therefore solely your liability. As regards the responsibility, it will be limited to all damages in the value of the product which we delivered and you applied. Certainly, we do assure the immaculate quality of our products in concordance with our general sales and delivery conditions.